Teac HS-2 - Manual (Page 66)

66
TASCAM HS-2
Making a recording
Recording
When unit is stopped, press the REC key to put the
unit into recording standby. At this time, the
icon
indicates this transport status.
In recording standby, press the PLAY key to start
recording.
The transport status display at the top left of the Home
Screen changes into the recording status display and part
of the background of the Home Screen becomes red,
indicating that the unit is recording. The time counter
starts at the same time.
NOTE
• When stopped, pressing the PLAY key while pressing
and holding the REC key will also start recording.
NOTE
• Recording can also be controlled using parallel control
(except retaking).
• In take mode, even if you press the PLAY key while
holding the REC key during playback, you cannot
overwrite a recording.
CAUTION
When in recording standby, the parallel control signals
output are high for TALLY_RECORD and low for TALLY_
PAUSE. When in recording standby, the REC and PAUSE
keys on the front panel will be lit.
Stopping recording
To stop recording, press the STOP (RETAKE) key.
Retaking a recording
Press the STOP (RETAKE) key while pressing and holding
the SHIFT key to erase the last recorded take. (The
recorded audio file itself will be erased.)
If you press the PAUSE key during recording to record
multiple consecutive takes (files) and the
PAUSE MODE
item is set to
SPLIT
, this will only erase the last take. If it
is set to
NO SPLIT
, the recording is not split into multiple
takes, so this will erase the entire recording from start to
finish.
For details about the
PAUSE MODE
item see “FILE FORMAT
page” on page 90.
Playback
Project/session/take selection
1 Press the PROJECT key on the front panel to open
the
PROJECT
screen.
NOTE
You can also touch the session/take name area on the
Home Screen to open the
PROJECT
screen.
2 Touch the
e
button for the project that contains
the take you want to load to open the session se-
lection screen. If it is not the current project, a pop-
up window appears confirming that you want to
load it. Touch the
OK
button.
3 Touch the
e
button for the session that contains
the take you want to load to open the take selec-
tion screen. If it is not the current session, a pop-
up window appears confirming that you want to
load it. Touch the
OK
button.
8–Take mode