Teac HS-2 - Manual (Page 15)

TASCAM HS-2
15
. WORD/VIDEO IN connectors
This BNC-type connector is for input of a word clock
signal (44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz, 176.4 kHz,
192 kHz) or a video reference signal (NTSC/PAL black
burst signal, HDTV Tri-Level signal). Use the switch to
set whether or not to terminate with 75Ω.
/ WORD/VIDEO THRU/WORD OUT connectors
This BNC-type connector is for output of a word clock
signal (thru, 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz, 176.4
kHz, 192 kHz) or a video reference signal (IN connector
signal thru only).
Use the THRU/WORD OUT switch to set the signal
output.
! 75Ω OFF/ON and THRU/WORD OUT switch
Use this switch to make the following settings.
• Whether or not the WORD/VIDEO IN connector has
a terminator (75Ω)
• The WORD/VIDEO output THRU/OUT setting (OUT
is only for WORD)
@ ETHERNET connector
Use this Ethernet connector to connect to a network
for file transfer and to control this unit from an external
source.
# GROUND terminal
When using a TASCAM RC-HS20PD remote control
(sold separately), depending on the operating
environment, the color display might flicker or noise
might be heard when monitoring. If this occurs, use
the GROUND terminal. (Please prepare a wire to use
with the GROUND terminal.)
PARALLEL connector
The PARALLEL connector on the rear panel allows
external control of this unit. (TASCAM RC-SS20 can be
connected.) The pin assignments are as follows.
Pin No. Normal
RC-SS20
PonMode
I/O
1 GND GND
2 PLAY FLASH 1 I
3 STOP FLASH 2 I
4 RECORD FLASH 3 I
5 SKIP FWD FLASH 4 I
6 SKIP BWD FLASH 5 I
7 (Reserved) STOP I
8 FADER_START FADER_START I
9 (Reserved) (Reserved) O
10 TALLY_PAUSE TALLY_PAUSE O
11 TALLY_RECORD RESERVED O
12 TALLY_STOP TALLY_STOP O
13 TALLY_PLAY TALLY_PLAY O
14
REMOTE_SELECT,
H or Open
REMOTE_SELECT, L I
15 PAUSE FLASH 6 I
16 (Reserved) FLASH 7 I
17 AUX1, FF FLASH 8 I
18 AUX2, REW FLASH 9 I
19 AUX3, MARK FLASH 10 I
20 (Reserved) FLASH_PAGE I
21 (Reserved) (Reserved) O
22 TALLY_SD TALLY_SD*1 O
23 (Reserved) (Reserved) O
24 TALLY_CF TALLY_CF*2 O
25 +5V*3 +5V*3
I: Command input for transport control
Internal circuit, +5V pull-up
Triggers from a low input level of 50 msec or more
O: Command output, for tally output
The internal circuit is open collector (10Ω output
impedance)
Output level low when asserted
20 V dielectric strength, 35 mA maximum current
*1 Assigned to CF indicators when connected RC-SS20
*2 Assigned to CD indicators when connected RC-SS20
*3 +5V: 50 mA maximum supplied current
2−Names and functions of parts