Combining takes (combine), 8–take mode – Teac HS-2 User Manual

Page 73

TASCAM HS-2

Combining takes (Combine)

Combine a specified take with another one.

NOTE

You cannot combine takes in the following cases:

• The bit length, the number of channels, sampling

frequency, etc. are different.

• The file size of the combined takes exceeds

Max

File Size

shown on the

REC SETUP/FILE

FORMAT

screens.

• The capacity of the media is less than the file size of

the second of the 2 takes to be combined.

7$.(

1 Press the HOME key to display the Home Screen.
2 Set a take as the current take, which will be the for-

mer half of the combination.

3 Touch the

EDIT

button to display the pull-up menu.

Touch the

Combine

button on the pull-up menu.

4 When the take selection screen is displayed, touch

the -> button of a take to be combined with the

current take.
( The yellow icon indicates the first take that is to be

used for the combination that was selected at step 3.)

5 A confirmation message appears, and 4 seconds in

total before and after the combining point will be

played repeatedly. Touch the

button or press the

ENTER key to combine the takes. Touch the

CANCEL

button or press the EXIT/CANCEL key to stop the re-

peat play, and the take selection screen reopens.

6 During combining, a progress bar is shown in the

pop-up window. When combining is complete, the

pop-up window will disappear.

NOTE

• The file name of the initial take is used for the

combined take.

• The time code information from the initial take is used

in the combined take.

• If the combined number of mark points between the 2

takes exceeds 100, the 101st and subsequent ones will

be lost. These mark points cannot be recovered with

UNDO.

CAUTION

It is possible to combine takes that are already in use

in the timeline or playlist modes.
If you combine such takes, an error pop-up appears

when you attempt to play the corresponding region/

entry.

8–Take mode