Teac HS-2 - Manual (Page 13)

TASCAM HS-2
13
s SHIFT key
When stopped/in playback standby/during playback:
• Press the
. key while pressing and holding this
key to move to the previous mark, and resume the
same playback state.
• Press the / key while pressing and holding this
key to move to the next mark, and resume the same
playback state.
• Press the m [ ] or, [ ] key while
pressing and holding this key to search at high
speed.
• Press the JOG (SHUTTLE) key while pressing and
holding this key to activate the shuttle operation
mode.
• Press the STOP (RETAKE) key while pressing and
holding this key to retake the recording (erasing the
last recorded take).
• Press the CALL (CHASE) key while pressing and
holding this key to turn synchronization with
timecode ON/OFF.
d JOG (SHUTTLE) key and indicator
Use to enable use of the JOG/SHUTTLE dial. Press
this key to enable the jog operation mode of the
JOG/SHUTTLE dial. When this mode is enabled, this
indicator lights.
Press this key while pressing the SHIFT key to enable
the shuttle operation mode of the JOG/SHUTTLE dial.
When this is enabled, this indicator blinks.
Press this key again to disable either mode.
f JOG/SHUTTLE dial
When in jog operation mode, turn this to change the
playback position by a corresponding amount.
When in shuttle operation mode, turn this to adjust
the playback speed according to the degree of
rotation.
If you return to the original position when in shuttle
operation mode, the transport status is restored to
how it was before shuttle playback was begun.
2−Names and functions of parts