Figure 3: sf-3040, rear view – NavCom SF-3040 Rev.F User Manual
Page 29
SF-3040 Product User Guide
– Rev. F
1-27
Figure 3: SF-3040, Rear View
Refer to Chapter 3 for details on the
communication ports. Refer to the
Bluetooth Communications Setup
section for details on setting up the
Bluetooth
connection.
Refer to Appendix A for additional
considerations and restrictions.
Perform these steps to set up power:
1. Fully charge the battery pack for 12-hours after
each use (refer to Charging the Battery Packs in
this guide, if necessary).
2. Insert the batteries into the battery slot (refer to
Figure 54, if necessary).
3. Optional: Plug the optional AC power cord into the
optional Universal AC/DC power adapter.
Connect the male LEMO connector end of the
Power Adapter cable into the female connector
(labeled PWR) on the bottom of the SF-3040. Plug
the AC power cord into an AC receptacle.
Cable
connectors