NavCom SF-3040 Rev.F - Manual (Page 101)

SF-3040 Product User Guide
– Rev. F
5-99
 USB – COM1
 Configuration – Control or Data Port
 Default Baud Rates:

57600 bps (RS-232)

2 Mbps (USB)
This 7-pin port is normally used to output data to
other devices or machines that can make immediate
use of the precise positioning data available from the
SF-3040. The data port outputs Sapphire GNSS
Binary Messages and NMEA Messages and when
applying external dGNSS corrections, also serves as
the dGNSS correction input port.
 COM2 – Serial Communication Port (RS-232)
 Configuration – Control or Data Port
 Default Baud Rate: 57600 bps
This 6-pin port is normally used to input and output
proprietary messages used for navigation and
receiver setup. Table 16 describes the default
messages needed to best initiate surveying with
minimal effort.
The user has full control over the utilized message
types and their associated rates via either
StarUtil 3000 or a 3
rd
party software/utility.
 Bluetooth Virtual COM Port
 Configuration – Control Port
 Baud Rate – 230.4kbps
Th
e PC’s virtual COM port is used to input and output
proprietary messages used for navigation and
receiver setup. Table 16 describes the default
messages needed to best initiate surveying with
minimal effort. RTK correction data may be
interleaved with control data via the [PACKB]