NavCom SF-3040 Rev.F - Manual (Page 107)

SF-3040 Product User Guide
– Rev. F
5-105

The user may reset all of the user-
controlled configuration parameters to
the factory default values (see the next
section, Profile NONE).

A new profile sent to the receiver replaces the
currently used profile, but it does not necessarily
replace all of the current parameter settings.
The new profile replaces only those parameter
settings that it specifies.
For example:
The default navigation elevation mask is 7

.
The user changes the elevation mask to 12

in
a profile named “Test”. The user subsequently
sends profile “RTK” to the receiver. It replaces
“Test” and changes navigation mode settings
and port assignments.
But profile “RTK” does not specify a setting for
the navigation elevation mask. So, the
elevation mask remains at 12

, as previously
set by the “Test” profile.

Refer to the Sapphire Technical Reference
Manual for detailed information on the
[PROFILE] and [USEPROFILE] commands (see
Related Documents in the fore-matter).
Profile NONE
The command [USEPROFILE] NONE resets all of the
user-controlled configuration parameters to the
factory
default values. The receiver’s profile remains
set to NONE until another profile is successfully input.

The profile NONE is subject to change.