NavCom SF-3040 Rev.F - Manual (Page 119)

SF-3040 Product User Guide
– Rev. F
6-117
Removing the Battery Packs
Remove the battery packs individually.
If the receiver is turned on, remove the weakest
battery first and exchange it for a fully charged
battery.
Follow these steps to remove the battery packs:
1. To open the battery chamber, hold the SF-3040
upright and press downward on the lower half
(protruding part) of the black button on the battery
chamber (refer to Figure 53).
2. With the thumb of one hand, gently push to the
locking clip to the outside on the battery chamber;
the battery pack should pop out enough to be free
of the chamber.
3. Remove the battery pack.
Battery Usage and Storage Precautions
Adhere to the following precautions when using the
battery packs and charger:
Charge the battery packs only with
the supplied battery charger (PN
98-214401)
otherwise, damage to
the battery packs could occur.
Do not disassemble or modify the
battery packs; there are no user-
serviceable parts inside. The
batteries contain safety and
protection devices, which, if
damaged, may cause the battery to
generate heat, explode, or ignite.