Removing the radio modem – NavCom SF-3040 Rev.F User Manual
Page 132
SF-3040 Product User Guide
– Rev. F
7-130
Removing the Radio Modem
Follow these steps to remove the radio modem from
the SF-3040 radio modem chamber:
1. Turn the SF-3040 off.
2. Open the radio modem chamber, press downward
on the black button (refer to Figure 56).
3. Carefully pull the antenna connector plug from the
radio antenna port.
The connector fits snugly. Do not use a
prying device (i.e. screwdriver) to
remove the connector. Instead, needle-
nose pliers may be used on the
connector body only; do not use the
pliers at the coaxial cable connection.
4. Slide the radio modem out.
5. Use a small tie-wrap to secure the antenna
connector to the coaxial cable on the door.
Failure to perform Step 5 above may
allow the MCX connector to
momentarily touch the radio modem
interface power port and short the
SF-3040 power supply out.
.