NavCom SF-3040 Rev.F - Manual (Page 161)

SF-3040 Product User Guide
– Rev. F
D-159
D ............................ Networked Transport of
RTCM Internet Protocol (NTRIP) Setup
Configure the SF-3040 for Wireless
Connection
Perform these steps:
1. Connect the SF-3040 to the computer either on
the USB port or the COM1 port.
2. Start StarUtil 3000 or another application that
provides an Input Terminal.
3. Configure the SF-3040 as a rover:
[RTKMODE]ROVER, RTCM, 1
4. Schedule the following messages (example below
uses port USB1):
[OUTPUT]PVT1B,ONTIME,1,USB1
[OUTPUT]ECHODGPSB,ONCHANGE,,USB1
[OUTPUT]RTKSTATUS1B,ONTIME,1,USB1
5. Configure the modem control parameters; for
example, assuming T-Mobile as service provider,
enter the following command on the Input
Terminal
[MODEMCONFIG] ’’’’,’’’’,”1, ‘IP’,
‘internet2.voicestream.com’’’

For providers other than T-Mobile, the
APN ‘internet2.voicestream.com’ should
be changed to the appropriate APN. If in
doubt, sometimes a blank APN works.