Measurement Computing Data Acquisition Systems rev.10.4 - Manual (Page 249)

Programmer’s Manual
908794
Daq API Command Reference 4.5-19
(continued)
Definition Description
DdiSerialNumber Serial Number String
DdiAdcClockSource Current Clock Source
DdiFirmwareVersion Firmware Version (String)
DdiHardwareVersion Hardware Version (String)
DdiDriverVersion Driver Version (String)
DdiAdcTriggerScan Trigger Scan Number (DWORD)
DdiAdcPreTriggerCount Amount of Pre-Trigger Scans (DWORD)
DdiAdcPostTriggerCount Amount of Post-Trigger Scans (DWORD)
DdiSetpointStatusReg Returns 16-bit value indicating setpoint status
DdiWbk18OpenSensorStatus Returns opens sensor status for specified WBK18 channel
DdiWbk18OpenSensorStatus Returns opens sensor status for specified WBK18 channel
DdiWbk18PosOverRangeStatus Returns positive over-range status for specified WBK18 channel
DdiWbk18NegOverRangeStatus Returns negative over-range status for specified WBK18 channel
DdiWbk18LowPassMode Returns current Low Pass mode enumeration value
DdiWbk18LowPassCutOff Returns current Low Pass cutoff frequency
DdiWbk18HighPassCutOff Returns current High Pass mode enumeration value
DdiWbk18CurrentSrc Returns current ICP current state
DdiWbk18OverRangeEnable Returns current state of over range enable in the form a an 8 bit mask
DdiWbk18esMode Returns current mode
DdiWbk18esFreq Returns current frequency setting – register read
DdiWbk18esAmplitude Returns an enumeration representing the current amplitude setting –register read
DdiWbk18esFreqCycleTime Returns current cycle time in microseconds
DdiWbk18esFreqDurationTime Returns current duration in microseconds
DdiWbk18OverRangeLimit Returns current over range limit setting as a percentage.
DdiWbk18esRelay Returns current relay position setting – register read
DdiWbk18OpenSensorStatusAll Returns an 8 bit value indicating status for all 8 WBK18 channels
DdiWbk18PosOverRangeStatusAll Returns an 8 bit value indicating status for all 8 WBK18 channels
DdiWbk18NegOverRangeStatusAll Returns an 8 bit value indicating status for all 8 WBK18 channels
DdiWbk18TEDsStatus
Returns one byte of status:
0 = TEDs Transducer Found -- ,Operation complete
1 = TEDS Operation Busy
2 = Operation complete, NO TEDs Found
4 = Channel is shorted
DdiWbk18TEDsData
Returns 34 byte array of TEDs info as follows:
info[0] = Status
info[1] = Amount of TEDS data available
info[2] = First byte of TEDS data if available
info[3..33] = Rest of TEDS data
DdiWbk18TEDsDataCount Returns the Amount of TEDS data available
DdiChSubTypeInfo Returns Channel sub type
DdiChOptionSubTypeInfo Returns Option sub type
DdiSetpointStatusReg Returns a 16 bit value indicating the status for all channels