IHSE USA 480 Series Draco tera enterprise - Manual (Page 110)

Draco tera
110
2013-08-14
5.6.2 Creating Fixed Port Extender Units
In order to create a fixed port extender unit (e. g. USB 2.0), proceed as
follows:
1. Press the button New.
2. Select, if a template of a USB 2.0 CON unit (USB CON Unit) or
USB 2.0 CPU unit (USB CPU Unit) should be used.
3. Press the button OK.
4. Determine a port at the matrix that should be used with the USB 2.0
extender unit (Fixed Port). As an option the name of the USB 2.0
extender unit can be changed (Name).
5. Press the button Apply to save the new extender unit.
Created extender units are always set as fixed port extenders. These
configurations are necessary, if you want to switch e. g. USB 2.0
connections via the matrix.
5.6.3 Deleting Flex-Port Extender Units
Deleting Flex-Port extender units connected to the matrix is not possible.
5.6.4 Deleting Fixed Port Extender Units
In order to delete a fixed port extender unit (e. g. USB 2.0), proceed as
follows:
1. Verify that the fixed port extender unit to be deleted is currently not
assigned to a device.
2. Select the fixed port extender unit to be deleted in the selection list on
the left side of the menu EXT Units and confirm with the key .
3. Press the button Delete.
4. Confirm the delete process with the button Okay.
In order to make a fixed port available again for Flex-Port extender units
after deleting a fixed port extender unit, a restart of the I/O board is
obligatory.
Pos: 67 /806-IHSE/zz_Layout/Seitenumbruch @ 8\mod_1348581820516_0.doc @ 69462 @ @ 1