Fluke Biomedical ProSim 6 - Manual (Page 77)

Vital Signs Simulator
How to Save and View Test Results (ProSim 8 only)
65
5. Push , , , and  to highlight a character for the test ID.
6. Push to add the highlighted character to the test ID.
7. Do steps 5 and 6 for each character in the test ID. You can have the maximum
number of characters that fit in the test ID field in the display. If you use more of the
narrow characters like I and 1, you can have more characters in the test ID than when
wider characters are used.
Additional characters are available when you push the Special Characters
softkey. To go back to the normal characters, push the Back Softkey.
Note
If you make a mistake, push the Back Space softkey to remove the last
character added. A Clear All softkey removes all characters in the test ID
field of the display.
8. Push the Done softkey when you have all the characters in the test ID.
How to Save Test Results
Note
Before you save test results, make sure the operator ID and test ID are set
correctly.
Each function of the Product lets you save test results data through a Save softkey. To
save test results:
Note
If the Save softkey label is not shown in the display, it means you can not
save data at this point.
1. Push the Save softkey to show the Save screen. The screen in Figure 55 is the save
screen for the temperature simulation function.
glh039.bmp
Figure 55. Save Screen
Note
The next step is valid only when the Enter Observed softkey appears in the
display.
2. To add measurements shown in the UUT display to the test results record, push the
Enter Observed softkey.
Note
If there is more than one simulation parameter, you have to highlight a
parameter and push  before the next step.