Fluke Biomedical ProSim 6 - Manual (Page 23)

Vital Signs Simulator
ECG Function
11
All the vital sign simulation parameters are set to the values contained in the pre-defined
simulation.
You can customize the seven factory simulations and seven custom simulations through
the Ansur functionality.
ECG Function
The Product simulates normal heart signals (ECG) as well as heart signals for a variety of
arrhythmias. Heart rate (beats per minute), signal amplitude, and ST segment elevation
are all controlled by the Product through the user interface. Artifacts can also be
simulated.
To measure the ECG performance of a monitor, connect the Product to the monitor as
shown in Figure 6. A maximum of ten ECG leads can be connected to Product.
ProSim 8
Patient
Monitor
ECG
Cable
glh030.eps
Figure 6. ECG Connections
How to Set the ECG Parameters
Whenever the Product is turned on, the display shows the defaults for heart rate
(60 BPM) with a patient type of Adult. Although not shown on the initial display, the
signal amplitude is 1 mV. To set any of the ECG parameters, push . The ECG
screen shown in Figure 7 shows in the display.
glh004.bmp
Figure 7. ECG Screen