Fluke Biomedical ProSim 6 - Manual (Page 65)

Vital Signs Simulator
Oximeter SpO2 Optical Emitter and Detector
53
Connect the SpO2 artificial finger to the SpO2 jack on the front panel as shown in
Figure 47.
ProSim 8
SpO 2 Cable
Pulse
Oximeter
Sensor
Patient
Monitor
ProSim
Oximeter SpO 2 Optical
Emitter and Detector
glh029.eps
Figure 47. Oximeter SpO2 Optical Emitter and Detector Connections
Note
When you put the oximeter sensor on the artificial finger, make sure the red
LEDs (light emitting diodes) are on the bottom.
Put the SpO2 sensor on the artificial finger as shown in Figure 48. Place the sensor with
the LEDs on the bottom of the artificial finger. While you put the sensor on the artifical
finger, monitor the signal indicator along the bottom of the Product display. Adjust the
sensor on the finger for maximum signal strength.