Fluke Biomedical ProSim 6 - Manual (Page 55)

Vital Signs Simulator
Non-Invasive Blood Pressure Simulation and Tests
43
Figure 33 shows the neonatal blood pressure cuff mandrel.
Large
Medi u m
Small
fcv012.eps
Figure 33. Neonatal Blood Pressure Cuff Mandrel
To set the blood pressure simulation, push  to show the NIBP screen in Figure 34 in
the display.
glh003.bmp
Figure 34. Non-Invasive Blood Pressure Screen
Pressure, heart rate, pulse volume, brand, and wave are set through the front-panel
controls to simulate different patient conditions. Arrhythmia waveforms are also
simulated in the NIBP simulation (set through ECG). To set the Blood Pressure:
1. Push  or  to highlight the Pressure variable.
2. Push .
Systolic and diastolic pressures are set separately.
3. Push  or  to highlight the systolic or diastolic pressure value.
4. Push  or  to increase or decrease the pressure value in 1 mmHg steps.
Note
When you hold down the direction key, the step size will change to
10 mmHg until the key is released.
5. Push  to set the pressure and go back to the NIBP screen.