Fluke Biomedical ProSim 6 - Manual (Page 28)

ProSim 6/8
Users Manual
16
Table 10. Arrhythmias by Wave Group (cont.)
Arrhythmia Wave Group Available in
PVC1 LV R on T Premature ProSim 8 only
PVC2 Right Vent Premature ProSim 8 only
PVC2 RV Early Premature ProSim 8 only
PVC2 RV R on T Premature ProSim 8 only
Rt Bndl Branch Block Conduction ProSim 6 and 8
Run of PVCs Ventricular ProSim 8 only
Sinus Arrhythmia Supraventricular ProSim 6 and 8
Stable Tachycardias ACLS ProSim 8 only
Supra VTach Supraventricular ProSim 8 only
Trigeminy Ventricular ProSim 8 only
Unstable Tachycardias ACLS ProSim 8 only
Ventricular Fibrillation Ventricular ProSim 6 and 8
Wide Complex Tach ACLS ProSim 8 only
1st Deg AV Block Conduction ProSim 8 only
2nd Deg AV Block T1 Conduction ProSim 6 and 8
2nd Deg AV Block T2 Conduction ProSim 8 only
3rd Deg AV Block Conduction ProSim 8 only
Supraventricular Arrhythmias
To set a supraventricular arrhythmia:
1. From the ECG screen, push  or  to highlight the Wave Group value.
2. Push .
3. Push  or  to highlight Supraventricular in the wave group list.
4. Push .
5. Push  or  to highlight the Waveform value.
6. Push .
7. Push  or  to highlight a waveform in the list.
8. Push to set the arrhythmia waveform and go back to the ECG:
Supraventricular screen.
The amplitude of all supraventricular arrhythmia waveforms can be adjusted. See the
How to Set the ECG Parameters section above. ECG signal artifacts can also be added to
each arrhythmia signal. See the How to Simulate an ECG Artifact section above.
The atrial fibrillation arrhythmia has one variable not available on the other
supraventricular arrhythmias. The type variable can be set to coarse or fine. To change
the type variable with the atrial fibrillation waveform set:
1. Push  or  to highlight the Type value.
2. Push .