beautypg.com

1 led indicators – Comtech EF Data CDM-570 User Manual

Page 88

background image

CDM-570/570L Satellite Modem with Optional IP Module

Revision 12

Front Panel Operation

MN/CDM570L.IOM

5–2

5.1.1 LED Indicators

In general, the Alarm relay state will reflect the state of
the Front Panel LEDs. For instance, if the Unit Status
LED is red, the Unit Alarm relay will be active, etc. The
one exception is the Transmit Traffic relay. This will
only be activated if a Transmit Traffic Fault exists – it
does not reflect the state of the TX carrier.


The behavior of the eight front panel LED Indicators is as follows:

LED

Condition

Description

UNIT STATUS

Red

A Unit Fault exists (Example: PSU fault)

Orange

No Unit Faults, but a Traffic Fault, or ODU (BUC or LNB) fault exists

Green

No Unit Faults, or Traffic Faults

Tx TRAFFIC

Green

No Tx Traffic Faults

Off

A Tx Traffic fault exists OR the Tx Carrier is in OFF state

Rx TRAFFIC

Green

No Rx Traffic Faults (demod and Viterbi decoder are locked, everything is

OK)

Off

An Rx Traffic fault exists (the demod may still be OK – check the fault status

of the modem from the Monitor menu).

ONLINE

Green

The modem is On Line, and carrying traffic

Off

The modem is Off Line (standby) - forced by externally connected 1:1 or 1:N

redundancy system

STORED EVENT

Orange

There is a Stored Event in the log, which can be viewed from the front panel,

or retrieved via the remote control interface

Off

There are no Stored Events

REMOTE

Orange

The modem is in Remote Mode - local monitoring is possible, but no local

control

Off

The modem is in Local Mode - remote monitoring is possible, but no remote
control

Flashing

ODU FSK control has been enabled, and there is a communications fault

EDMAC MODE

Orange

Framing on, EDMAC on, and unit defined as Slave - local monitoring is

possible, but no local control

Off

Either the modem is in Transparent mode (no framing), or the framing has
been selected, but in AUPC-only mode, or EDMAC Master configuration

TEST MODE

Orange

A Test Mode is selected (Example: IF Loopback)

Off

There is no Test Mode currently selected


This manual is related to the following products: