Comtech EF Data CDM-570 - Manual (Page 379)

CDM-570/570L Satellite Modem with Optional IP Module Revision 12
Appendix D MN/CDM570L.IOM
D–29
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction Code
and Qualifier)
Response to
Query
Warm-up Delay WUD= 1 byte,
value 0 or 1 Command or Query.
Warm-up Delay for internal frequency reference (OCXO)
0=Disabled (instant on – no delay for OCXO to reach temperature)
1=Enabled (unit waits until OCXO reaches correct temperature)
Example: WUD=1 (selects Warm-up Delay) WUD=
WUD?
WUD*
WUD# WUD? WUD=x
(see Description of
Arguments)
D.6.4 Bulk Commands and Queries
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction Code
and Qualifier)
Response to
Query
OGC Outdoor Unit
Global
Configuration
OGC= 50 Bytes Command or Query – CDM-570L only.
ODU Global Configuration of CDM-570L in the form
aabcdexxxxhhhhiiiijjjjjkxxxxxxlmnnnooopppppqxxxxxx, where:
OGC=
OGC?
OGC*
OGC# OGC?
OGC?n OGC=aabcdfxxxhhh
hiiiijjjjjkxxxxxxlmnnn
ooopppppqxxxxxx
(see Description of
Arguments)
Where n=0 to 9
returns the OGC
portion of 1 of 10
stored
configurations
(see Description of
Arguments)
aa = BUC Address
b = BUC FSK comms enable
c = BUC Power Control
d = BUC 10MHz Frequency Reference enable
e = BUC Tx Output Enable
xxxx = expansion bytes
hhhh = BUC Low Alarm Limit
iiii = BUC High Alarm Limit
jjjjjk = BUC LO frequency, mix sign
xxxxxx = expansion bytes
l = LNB Power Control
m = LNB 10MHz Frequency Reference enable
nnn = LNB Low Alarm Limit
ooo = LNB High Alarm Limit
pppppq = LNB LO Frequency, mix sign
xxxxxx = expansion bytes
Any unavailable parameters will be filled with xxx. same as BAD
same as BCE
same as BPC
same as BFR
same as BOE
same as BCL
same as BCH
same as BLO
same as LPC
same as LFR
same as LCL
same as LCH
same as LLO