Comtech EF Data CDM-570 - Manual (Page 463)

K–1
Appendix K. CDM-570 ODU
(CSAT-5060
OR
KST-2000A/B)
OPERATION
K.1 Introduction
The CDM-570 Satellite Modem permits the configuration, monitoring, and control of a Comtech
EF Data RF Transceiver (referred to throughout this appendix as an Outdoor Unit, or ODU).
The following ODUs are compatible for operation with the CDM-570:
• CSAT-5060 series (5 to 25, 50 & 100 Watts) C-Band Transceivers
• KST-2000A (LNA) Ku-Band Satellite Transceiver
• KST-2000B (LNB) Ku-Band Satellite Transceiver
ODU operation may be monitored and controlled via the following methods:
• By using ODU remote commands through Serial Remote or Telnet
• By using the keypad and display via the front panel of a CDM-570 Modem
• By using the CDM-570 Base Modem HTTP Interface
• By using the SNMP Interface with CSAT-5060 or KST-2000A/B Transceiver MIB
K.2 ODU Remote Control Address Setup
The ODU connected to a CDM-570 through FSK (Frequency Shift Keying) is remotely
monitored and controlled by using ODU remote commands through Serial Remote or Telnet, or
by using the modem’s HTTP Interface. The address of the ODU is set up as follows:
• For local-end ODUs:
o Use Modem’s RC address + 1 for Standalone unit or Online unit in a 1:1 Redundancy
System
o Use Modem’s RC address + 2 for Offline unit in a 1:1 Redundancy System