Comtech EF Data CDM-570 - Manual (Page 405)

CDM-570/570L Satellite Modem with Optional IP Module Revision 12
Appendix E MN/CDM570L.IOM
E–19
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction Code
and Qualifier)
Response to
Query
QoS Rule (cont.)
Where A = TCP/UDP Source Port range
SPS=aaaaa [Source Port range Start]
Where B = [Source Port range Finish]
SPF=bbbbb
Where C = [Dest Port range Start]
DPS=ccccc
Where D = [Dest Port range Finish]
DPF=ddddd
Where m =
MINBW = mmmmm (meaningful in min.max mode). This is 0 in Max Priority mode.
The number should be mentioned with preceding zeros, to make it a fixed length of
5-chars.
Where M =
MXB=MMMMM (meaningful in max/pri and min./max modes only). The number
should be mentioned with preceding zeros, to make it a fixed length of 5-chars.
W = WRED = 0-No 1-Yes
F = FILTER = 0-No 1-Yes
Example:
>0001/qsr[1]=05|5|***.***.***.***/**|***.***.***.***/**|*****|*****|*****|*****|00000|22222|0|1
Example: [Default rule]
Note: All QoS related commands can only be issued only when the system is in
QoS-Max/Priority or QoS-Min/Max mode. It may return QSR! while not in any of
these modes.
Number of QoS
Rule entries N/A QSN=2 bytes
numerical Query only.
Returns the number of active QoS rules. Does not count default rule.
Note: This command should be issued whenever a new rule is added/deleted. QSN =
QSN?
QSN? QSN = xxx
(see description of
arguments)
Delete a QoS Rule
entry QSD= QSD =2bytes,
numerical Command only.
Deletes the QoS rule entry at the specified index number
Example: QSD=3 (deletes the 3
rd QoS rule)
QSD =
QSD!
N/A
QSD = xx
(see description of
arguments)
QoS Typical
System Latency QTL= 1-Byte value
0 – 5 Seconds. Command or Query.
Sets/Gets the QoS typical system latency
At low datarates of up to 1Mbps this value can range from 0 – 5 Seconds..
At datarates above 1Mbps, the value range from 0 – 2 Seconds. QTL =
QTL! QTL? QTL=x
X – A value of 0-5
Seconds.