E.5.1 ip commands and queries, E.5.1.1 admin commands and queries – Comtech EF Data CDM-570 User Manual
Page 395
CDM-570/570L Satellite Modem with Optional IP Module
Revision 12
Appendix E
MN/CDM570L.IOM
E–9
E.5.1 IP Commands and Queries
E.5.1.1 Admin Commands and Queries
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to Query
Description of Arguments
Response to
Command
Query
(Instruction Code
and Qualifier)
Response to
Query
System Working
Mode
SWM=
1 byte, value of 0
through 1
Command or Query, where:
1=Router-Small Network
2=Router-Large Network
3=Router-Point to Point
4=Router-Vipersat
5=Managed Switch
Router-Vipersat mode needs the ViperSat option to be available on the modem.
Changing the address/working mode may reboot the modem.
SWM=
SWM!
SWM?
SWM =x
(see description of
arguments)
Managed Switch
Multicast Option
EMO=
1 byte, value of 0 or
1
Command or Query, where:
0=Disabled
1= Enabled
Enables or disabled forwarding of multicast traffic while in Managed Switch mode.
Valid only when in Managed Switch mode on 570.
EMO =
EMO!
EMO?
EMO =x
(see description of
arguments)
Header
Compression
Refresh rate –
UDP/RTP1
HRR=
3 bytes
Command or Query.
Header compression refresh rate, 1 to 600
Resolution=1 packet
Refresh rate for UDP/RTP1 streams.
Example: HRR=50
Restrictions: 570 only
HRR =
HRR!
HRR?
HRR =xxx
(see description of
arguments)
Header
Compression
Refresh rate –UDP
HRU=
3 bytes
Command or Query.
Header compression refresh rate, 1 to 600
Resolution=1 packet
Refresh rate for UDP only stream.
Example: HRU =50
Restrictions: 570 only
HRU =
HRU!
HRU?
HRU =xxx
(see description of
arguments)