Comtech EF Data CDM-570 - Manual (Page 466)

CDM-570/570L Satellite Modem with Optional IP Module Revision 12
Appendix K MN/CDM570L.IOM
K–4
K.3.3 SELECT: (Main) Menu
SELECT: Config Test Info
Monitor Save/Ld Util ODU
The table that follows identifies the commands comprising the CDM-570 main menu, and the
content section in this manual where explicit information may be referenced, either in this
appendix or in Chapter 5. FRONT PANEL OPERATION:
Menu Branch
(For more info, see...)
Description
Config
(Chapter Sect. 5.2.2.1)
Used to fully configure the modem.
Test
(Chapter Sect. 5.2.2.3)
Used to invoke one of several test modes (loopbacks, for example).
Info
(Chapter Sect. 5.2.2.4)
(Information) Used to view information on the modem, without having to go
into configuration screens.
Monitor
(Chapter Sect. 5.2.2.2) Used to monitor the alarm status of the modem, to view the log of stored
events, and to display the Receive Parameters screen.
Save/Ld
(Chapter Sect. 5.2.2.5)
(Save/Load) Used to save and to retrieve up to 10 different modem
configurations.
Util
(Chapter Sect. 5.2.2.6)
(Utility) Used to perform miscellaneous functions, such as setting the Real-time
clock, adjusting the display brightness, etc.
ODU
(Appendix K.3.2:
K.3.2.1 for CSAT-5060
K.3.2.2 for KST-2000A/B)
(Outdoor Unit) Used to monitor and control a Comtech EF Data RF
Transceiver (CSAT-5060 or KST-2000A/B), if connected.
For ODU operation, use the
◄ ► arrow keys to select ODU, and then press ENTER.
K.3.3.1 (SELECT:) ODU
Transceiver Control:
Disable Enable (◄ ►,ENT)
Use the
◄ ► arrow keys to select Disable or Enable, and then press ENTER. Note the
following:
Disable This menu item turns OFF the FSK link to the ODU
Enable This menu item turns ON the FSK link to the ODU
Once the FSK link to the ODU is enabled, the CDM-570 senses the active ODU model and
automatically adjusts the front panel menu selections specific to that product. Sections K.3.3.1.1
and K.3.3.1.2 address front panel operation functionality as it is adapts to CSAT-5060 or