Comtech EF Data CDM-570 - Manual (Page 75)

CDM-570/570L Satellite Modem with Optional IP Module Revision 12
Rear Panel Connectors and Pinouts MN/CDM570L.IOM
3–11
3.5 Power and Ground Connections
3.5.1 Alternating Current (AC) Power Connector (Standard)
A standard, detachable, non-locking, 3-prong power cord (IEC plug)
supplies the Alternating Current (AC) power to the CDM-570 or
CDM-570L units.
Note the following:
AC Power Specifications
Input Power 40W maximum, 20W typical
Input Voltage
100 - 240 volts AC, +6%/-10% - autosensing
(total absolute max. range is 90 - 254 volts AC)
Connector Type IEC
Fuse Protection
Use two (2X) 20 mm Slow-Blow fuses for line and neutral fusing – fuses are contained
within a fuse holder that is press-fit into the body of the IEC power module:
• Use 5.0A fuses for 115 volt AC operation
• Use 2.5A fuses for 230 volt AC operation
3.5.2 Optional Direct Current (DC) Power Connector
3.5.2.1 24 V or 48V DC Units – CDM-570 or CDM-570L Units
This optional connector supplies the 24V or 48V Direct Current (DC)
power to the CDM-570 or CDM-570L units.
Note the following:
DC Power Specifications
Input Power
48V 48 watts typical, 55 watts maximum
24V TBD
Input Voltage
48V 48 volts DC nominal (43 volts to 60 volts)
24V 24 volts DC nominal (20 volts to 36 volts)
Connector Type Corcom PS series
Mating Connector Corcom GA210 or Molex 03-12-1026
Fuse Protection
Usetwo (2X) 20 mm Slow-Blow fuses for positive and return fusing – fuses are
contained within a fuse holder that is press-fit into the body of the IEC power module:
• Use T5A fuses for units without a BUC
• Use T8A fuses for units with a BUC