Comtech EF Data CDM-570 - Manual (Page 269)

CDM-570/570L Satellite Modem with Optional IP Module Revision 12
Ethernet IP Module Interface MN/CDM570L.IOM
13–63
13.6.2.6.3 Maint | Save
Figure 13-36. Maint | Save page
This page appears once the Save hyperlink is selected. If running IP Module V1/MPP-50
Firmware Version 1.5.3.2 or later, all configuration changes made via the IP Module HTTP
Interface are automatically saved to Flash memory until either a new round of settings updates is
initiated, or all settings are restored to the original factory defaults using the ‘Maint |
Operations’ page.
Press [Backspace] on the keyboard as prompted by this page, or select any one of the HTTP
Interface navigation tabs/hyperlinks, to return to the previously active HTTP Interface page or to
select other modem functions.
When the Working Mode is set to Vipersat, Base Modem and IP Module
modifications are not automatically saved and will be lost if the unit is rebooted.
Additionally, if the Working Mode is set to Vipersat the unit may also load the
Vipersat Homestate configuration upon reboot.
For specific information about CDM-570/570L IP Module operation when
deployed in a Vipersat system, see adjunct Comtech EF Data publication
MN/22125 – Vipersat CDM-570/570L Satellite Network Modem Router User Guide.