Comtech EF Data CDM-570 - Manual (Page 400)

CDM-570/570L Satellite Modem with Optional IP Module Revision 12
Appendix E MN/CDM570L.IOM
E–14
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to Query
Description of Arguments
Response to
Command
Query
(Instruction Code
and Qualifier)
Response to
Query
SNMP
Write Community SWC= 255 bytes,
characters, no
spaces Command or Query.
SNMP write community string. Empty string is not allowed
Example: <1/SWC =public SWC =
SWC!
SWC? SWC =x
(see description of
arguments)
SNMP
Trap Community STC= 255 bytes,
characters, no
spaces Command or Query.
SNMP Trap community string. Empty string is not allowed
Example: <1/STC =trapcomm STC =
STC!
STC? STC =x
(see description of
arguments)
SNMP Trap
Destination IP
Address STA= 15 bytes,
Numerical Command or Query.
Used to set the IP address of the SNMP Trap destination IP Address where traps
will be sent, in the format:
xxx.xxx.xxx.xxx is the IP address
Example: <1/STA=010.006.030.001
Returns >0001/STA=0.0.0.0 When not configured. STA =
STA!
STA? STA =
xx.xxx.xxx.xxx (see
description of
arguments)
SNMP Trap
Destination IP
Address-2 STB= 15 bytes,
Numerical Command or Query.
Used to set the IP address of the SNMP Trap destination IP Address where traps
will be sent, in the format:
xxx.xxx.xxx.xxx is the IP address
Example: 010.006.030.001
Returns >0001/STB=0.0.0.0 When not configured. STB =
STB!
STB? STB =
xx.xxx.xxx.xxx (see
description of
arguments)
SNMP Trap Version STV= 1 byte, value of 0 or
1 Command or Query.
1=Snmpv1
2=Snmpv2
Specifies the version of SNMP traps that should be sent. STV =
STV!
STV? STV = x
(see description of
arguments)
SNMP Trap Enable
Authentication
Traps SAT= 1 byte, value of 1 or
2 Command or Query, where:
2=Disabled
1= Enabled
Enables or disables sending SNMP authentication traps. SAT =
SAT!
SAT? SAT =x
(see description of
arguments)
SNMP
System Contact SSC= 128 bytes,
characters, Command or Query.
SNMP System Contact string
Example: <1/SSC=Joe Net Admin. If not configured it returns empty string.
<1/SSC= SSC =
SSC!
STC? STC =x [1..128]
(see description of
arguments)
SNMP
System Name SSN= 128 bytes,
characters, Command or Query.
SNMP System Name string
Example: <1/SSN=Remote1. If not configured it returns empty string.
<1/SSC= SSN =
SSN!
SSN? SSN =x [1..128]
(see description of
arguments)