Comtech EF Data CDM-570 - Manual (Page 376)

CDM-570/570L Satellite Modem with Optional IP Module Revision 12
Appendix D MN/CDM570L.IOM
D–26
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction Code
and Qualifier)
Response to
Query
Number of Unread
stored Statistics N/A 3 bytes Query only.
Unit returns the number of stored statistics that remain Unread, in the form xxx.
Note: This means unread over the remote control.
Example: NUS=247 N/A NUS? NUS=xxx
(see Description of
Arguments)
Outdoor Unit
Comms Enable ODU= 1 byte,
value of 0 or 1
Command or Query – CDM-570 Only.
Enables or disables communications, via the FSK link, with a Comtech EF Data
transceiver (ODU), where:
0=Disabled
1=Enabled
Example: ODU=0 (selects Disabled) ODU=
ODU?
ODU*
ODU# ODU? ODU=x
(see Description of
Arguments)
ReCenter Buffer RCB= None Command only.
Forces the software to recenter the receive Plesiochronous/Doppler buffer.
Note: This command takes no arguments.
Example: RCB= RCB=
RCB?
RCB*
RCB# N/A N/A
Retrieve next 5
unread Stored
Events N/A 75 bytes Query only.
Unit returns the oldest 5 Stored Events which have not yet been read over the
remote control. Reply format: {CR}Sub-body{CR}Sub-body{CR}Sub-body{CR}Sub-
body{CR}Sub-body, where Sub-body= ABCddmmyyhhmmss,
A being the fault/clear indicator.
F=Fault
C=Clear
I=Info
B being the fault type where:
1=Unit
2=Rx Traffic
3=Tx Traffic
4=ODU
5= Power on/off, or log cleared
C is Fault Code numbers, as in FLT? or Info Code, which is:
0=Power Off
1=Power On
2=Log Cleared
3=Global Config Change
4=Redundancy Config Change
If there are less than 5 events to be retrieved, the remaining positions are padded
with zeros. If there are no new events, the response is RNE*. N/A RNE? RNE={CR}ABCddm
myyhhmmss{CR}A
BCddmmyyhhmms
s{CR}ABCddmmyy
hhmmss{CR}ABCd
dmmyyhhmmss
{CR}ABCddmmyyh
hmmss
(see description for
details of
arguments)