BayTech RPC Single-phase Conbined QS - Manual (Page 7)

RPC with or without Ethernet
6
protection.
CAUTION: Do not exceed the AC current rating for the selected model. (See
http://www.baytech.net/products/rpcseries.shtml for each RPC model).
CAUTION: In order to be absolutely removed from the power supply, the power cord must be
unplugged from the power source.
CAUTION: For PERMANENTLY CONNECTED EQUIPMENT, a readily accessible
disconnect device (Circuit Breaker rated not to exceed the amperage rating of the unit) shall be
incorporated in the fixed wiring between the power source and the Baytech unit. For
PLUGGABLE EQUIPMENT, the socket-outlet shall be installed near the equipment and easily
accessible. The outlets providing power to the unit shall be protected against over current and
short circuit by suitable rated protective devices.
Applying power illuminates a green LED on the front panel of the RPC. When the power
switch is off, devices connected to the unit are not receiving power.
CIRCUIT BREAKER
Depending on if the unit has circuit breakers, in the case of power overload, the circuit breaker
automatically trips. Determine the cause of the tripped circuit breaker, correct the problem then reset
the circuit breaker by depressing the circuit breaker switch. If an overload condition occurs, the RPC
status menu is still accessible. If all circuits are closed, the circuit breaker status menu will indicate
“On.” If the circuit breaker is tripped, the circuit breaker status will indicate “Off.” If no power cord is
attached to the “IN” receptacle, the circuit breaker status will indicate “Off”, indicating there is no
power available to the “OUT” receptacle.