BayTech RPC Single-phase Conbined QS - Manual (Page 21)

RPC with or without Ethernet
20
Type ‘help’ at the RPC prompt will display a list of commands to change the state of the outlets, unit
configuration, and internal sensor measurements.
HELP Options
Receptacle Controls
On, Off, Reboot, Lock, and Unlock are commands to control the individual outlets.
From the (RPC >) prompt, enter one of the following commands: ON n, OFF n, REBOOT n, where
“n” is the outlet number you want to command.
Example: To turn “On” Outlet 3, type ON 3 from the RPC prompt. If the confirmation option is turned
on, the RPC will display the following:
Type “Y” for yes or “N” for no. Likewise, typing ‘ON ALL’, ‘ON 0’, or ‘ON’ at the RPC > prompt
and responding “Y” for yes, turns ‘On’ all outlets. The OFF n command work similarly as the ON n
command.
The REBOOT n command will reboot or reset equipment attached to corresponding receptacle(s).
When the command to REBOOT (n) is sent from the RPC > prompt, the RPC powers ‘Off’ the
corresponding outlet(s) for approximately 10 seconds, then powers them ‘On’ in sequence.
This command only works on outlets which were ‘On’ prior to receiving the reboot command.
The LOCK n command is an admin user only command. This command allows the admin user to
lock an outlet in its current state. The user assigned to the outlet will not be able to change the outlet’s
state.
Example: To lock Outlet 1, type lock 1 at the RPC prompt.
RPC-4>help
On n --Turn on an Outlet, n=0,1...20,all
Off n --Turn off an Outlet, n=0,1...20,all
Reboot n --Reboot an Outlet, n=0,1...20,all
Status --RPC-28 Status
Config --Enter configuration mode
Lock n --Locks Outlet(s) state, n=0,1...20,all
Unlock n --Unlock Outlet(s) state, n=0,1...20,all
Current --Display True RMS Current
Voltage --Display True RMS Voltage
Power --Display Average Power
Clear --Reset the maximum detected current
Temp --Read current temperature
Logout --Logoff
Logoff --Logoff
Exit --Logoff
Password --Changes the current user password
Whoami --Displays the current user name
Unitid --Displays the unit ID
Type Help for a list of commands
Enter Request:
Turn On Outlet 3 (Y/N)?