BayTech RPC Single-phase Conbined QS - Manual (Page 17)

RPC with or without Ethernet
16
Figure 7
Figure 8
Login Setup Menu
Figure 9
Module: 1
Attention Character: ;
Outlet Control..................1
Status..........................S
Unit Status
Configure.......................C Unit Configuration menu
Unit Reset......................RU Terminates external connections, does not
affect the outlets.
Logout..........................T
Enter Request :s
Copyright(C) Bay Technical Associates 2003
URPC Ethernet Host Module
Revision F 1.07.05 Module 1
Hardware 1.01 Serial number 3800024 colilo version 1.05.01
Status..........................1
Status of all network options
Serial Port Configuration.......2 Setup the Serial port EIA232
Serial Port Device Name.........3 Change the EIA232 port name
Attention Character.............4 Type 5 times to access Network Main menu.
Disconnect Timeguard............5 Data received within the delay period,
is data, not attention character; thereby
preventing unwanted port disconnection
Connect Port ID Echo............6 Echo port name or module# & port#
Login Setup.....................7 Login Menu Serial/Telnet/Radius/TACACS
access control, manage users
Network Port Configuration......8 Network Port IP Address
Module Name.....................9 Change name of module
SNMP Configuration.............10 Trap address, Read/Write community names,
Enable/Disable SNMP
RPC Management.................11 Set up Voltage/Current/Sensor threshold
Web Server Configuration.......12 Enable/Disable Web, login, secure.
Radius Configuration...........13 Enable login, IP Address, Backup server,
Login timeout for Authentication server
Exit.........................X,CR
Enter Request :
Access Control..................1
Manage Users....................2
Radius Configuration............3
Exit............................X,CR