beautypg.com

At this point ftp the ssl.pem file into the module – BayTech RPC Single-phase Conbined QS User Manual

Page 49

background image

RPC with or without Ethernet

48

IMPORTANT: Do not type ‘Y’ unless you have received the instructions and firmware from
Baytech’s Technical Support. If you typed ’Y’ and see the following below, turn power off
than back on to the unit to close the firmware upgrade.


At this point follow the instruction to FTP the firmware into the unit.

Enable SSL Cert Upload

Selecting this option will allow the admin to upload an SSL Certificate to the RPC unit via ftp. The
filename of the certificate must be (ssl.pem). An SSL certificate is used by the unit to create secure
web connections. The RPC unit is shipped with a default SSL certificate. This certificate should be
replaced with one that better suits the user’s environment. The file format is checked after download to
insure that the certificate is valid.
Select this option to Enable SSL Cert Upload, the Host Module will display the following:

IMPORTANT: If you type ’Y’, the RPC will display the following. To stop this function
power-cycle the unit to close the SSL Certification Upload.


At this point FTP the ssl.pem file into the module.

Enable Configuration File Upload

This option allows the admin to upload a configuration file from your computer to the RPC.

Select Enable Configuration File and the RPC displays the following:

IMPORTANT: If you type ’Y’, the RPC displays the following below. To stop this function
power-cycle the unit to close the Configuration File Upload.

Enabling this will allow the firmware to be updated via ftp

Enable Firmware Upgrade ? (Y/N)

Waiting to receive compressed image file
----------------------------------------------------------------------------
----------------------------------------------------------------------------
---------------------------------------------

Enabling this will allow the SSL Certificate to be updated via ftp

Enable SSL Certificate Upload? (Y/N)

Waiting to receive ssl.pem SSL certificate file
--------------

Enabling this will allow the system configuration to be updated via ftp
THE UNIT WILL RESET AFTER CONFIGURATION IS COMPLETE
Enable Configuration File Upload? (Y/N)

This manual is related to the following products: