About this owner’s manual – BayTech RPC Single-phase Conbined QS User Manual
Page 5
RPC with or without Ethernet
4
ABOUT THIS OWNER’S MANUAL
This document provides information required for installing and operating your Bay Tech equipment. It
should allow the user to connect to, power up, and access an applications menu where peripheral
equipment can be controlled. We recommend reading this manual carefully, while placing special
emphasis on correct cabling and configuration. If you have any problems with your installation, please
contact a BayTech Applications Engineer at 228-563-7334, or toll free from anywhere in the United
States using 1-800-523-2702 or contact us at our Web Site,
www.baytech.net
.
BayTech manufactures many remote site management products, data switches, data collection
multiplexers, remote power controllers, and peripheral print sharers. If you would like information on
any of these products, please contact BayTech Customer Service at the above numbers or visit our web
site.
Conventions used in this manual include:
CAUTION: This term is used to denote any condition that could possibly result in physical
harm to personnel or damage to equipment.
IMPORTANT: This term is used to denote conditions that could result in the loss of
communications or to highlight the proper functioning of equipment.
NOTE: This term is used to denote items of interest to the user.
The information in this document is subject to change without notice. The statements, configurations,
technical data, and recommendations in this document are believed to be accurate and reliable, but are
presented without express or implied warranty. Users must take full responsibility for their
applications of any products specified in this document. The information in this document is
proprietary to Bay Technical Associates, Inc.
In the interest of improving internal design, operational function, and/or reliability, Bay Technical
Associates, Inc reserves the right to make changes to the products described in this document without
notice.
Bay Technical Associates, Inc does not assume any liability that may occur due to the use or
application of the product(s) or circuit layout(s) described herein.
BayTech units are in accordance with the general requirements of Standard for Information
Technology Equipment (ETL listed, conforms to ANSI/UL STD 60950-1-2003 CERTIFIED
CAN/CSA C22.2 NO. 60950-1-03,).
Model number description: RPC28 ADEN -30NC
RPC28 = base unit RPC28 group
A = High Voltage
D = LCD
E = Environmental Ports front panel
N = Network, Ethernet port.
F = Front panel LCD
L = LED
S = Sensor = Environmental port
-30 = Unit rated Amperage
NC = Normally Closed Relays upon initial and default power on.
We welcome any comments you may have about our products, and we hope that you will continue to
look to BayTech for your remote management needs.