BayTech RPC Single-phase Conbined QS - Manual (Page 39)

RPC with or without Ethernet
38
Access Control
This security feature allows the admin to enable or disable usernames and passwords for both network
and serial port access.
If either login has been enabled you will get a prompt similar to the following:
The default user and password is “root/baytech”, all lower case.
Manage Users
This menu allows the administrator to add/delete users and change their passwords for multiple users.
Usernames and passwords are case sensitive and alphanumeric. The root user can not be removed.
Select Manage User and the RPC displays the following:
NOTE: The port access mentioned in the User Management Menu below is not used in the
RPC series.
Type ‘a’ and press to add a user and their password, the RPC displays the following:
NOTE: If you forget your password, the administrator has to delete the user then add them
back in.
IMPORTANT: You can change the admin password. If you forget, resetting the unit back to
factory default is the only way to get the admin password back.
Access Control..................1
Manage Users....................2
Radius Configuration............4
Exit............................X,CR
Telnet Login Prompt Enable/Disable..1
Serial Login Prompt Enable/Disable..2
Coldfire login: root
Password:
or
Universal RPC login: root
Password:
User Management Menu
To change user password or port access, enter number of user.
To add/delete user, select appropriate menu choice.
SNMP V3 requires passwords that are between 8 and 31 characters long
Enter request, CR to exit menus.
A)...Add user
1)...root
Enter username (<= 31 characters)>user1
Enter new password (<= 31 characters)>******
Confirm by re-entering new password>******
Password change successful.