BayTech RPC Single-phase Conbined QS - Manual (Page 50)

RPC with or without Ethernet
49
At this point FTP the file into the unit. A successful file upload and the RPC will display:
Unsuccessful file upload and the RPC will display:
NOTE: This part of the program is derived from the DS62 module program, thus the DS62
reference.
Restore Configuration Defaults
This option allows the admin to restore the RPC configuration to factory defaults.
NOTE: The network default IP Address, Subnet, and Gateway is 0.0.0.0
Select Restore Configuration Defaults and the RPC displays the following:
A YES response and the RPC will display:
Get Current Configuration File
This option allows the admin to get a copy of the current RPC configuration file from the unit and
FTP’s it to your computer. The configuration file to be uploaded is named “confupload”. The file
maybe opened with any text file editor.
SETTING DEFAULT CONFIGURATION
set default password file
USING DEFAULT SSL CERTIFICATE
System reset in progress...
This board is a Universal RPC Controller
..........Uncompressing...done.
Waiting to receive configuration file
----------------------------------------------------------------------------
----------------------------------------------------------------
configuration file valid
updating ds62 configuration
***
ds62 host configuration complete
polling rpcs
Found RPC at mod 2 port 1
rpc polling complete
configuring rpcs
***error in config upload file or transfer operation***
ENABLING THIS WILL ERASE ALL CONFIGURATION BACK TO FACTORY DEFAULTS
AND RESET THE UNIT
Set Configuration to Factory Defaults? (Y/N)