BayTech RPC Single-phase Conbined QS - Manual (Page 56)

RPC with or without Ethernet
55
A Unit Reset takes approximately 10 seconds for the unit to reset. It will not affect the state the
energized outlets are in. It will not reset the unit to “Factory Default”, but it will terminate the external
communications.
Logout
Select T), will close the session to the unit, but may not close the terminal emulator session.
Troubleshooting:
Diagnostic LED Indications
To detect hardware, cabling, or configuration problems upon initialization of power, the RPC Series go
through a diagnostic sequence. To help determine the cause of the problem, the RPC Series have a CX
LED located on the front, right side of the unit. Upon initialization of power, refer to the table below
for interpretation.
INDICATION INTERPRETATION
Not lit
Normal unconnected operation
Brief flash followed by a solid illumination Established connection on network port or
serial port
Flashes 1 time per cycle Hardware or NIC problem
Flashes 2 times per cycle Configuration error
Flashes 3 times per cycle Cable or hub connection fault
Flashes 4 times per cycle Duplicate IP address
Remains lit without a brief flash prior to
illumination Memory error
NOTE: Diagnostic indications override a connection indication.