BayTech RPC Single-phase Conbined QS - Manual (Page 45)

RPC with or without Ethernet
44
Select A) to add a rule. Type an IP address, select whether to drop or accept the address. The RPC will
display the following:
Selecting either DROP or ACCEPT the packets and the RPC will assign filter the next rule number:
Selecting E), Enable IP Filtering will enable or disable the filtering function. The RPC displays:
Select V), View Rules allows the user to see any IP filtering. Note: At least one rule must be defined
for this option to be available. The RPC displays:
Select C), Set Default Target for ALL IP Addresses to accept or drop all. The RPC displays:
Filter Management Menu
Enter request or CR,X to exit menu.
A)...Add Rule
E)...Enable IP Filtering
D)...Delete Rule
V)...View Rules
F)...Flush Rules
C)...Set Default Target
Enter Request :a
Add a Rule
Please enter a single ip address filter
or an ip address block in ip/ notation.
: 70.150.140.95
Select a target option for this filter:
DROP the packet..................1
ACCEPT the packet................2
Exit.............................X,CR
Enter Request :1
Filter added as Rule 1.
IP Filtering is ENABLED. Enable? (Y/N): y
Rule Num Ip Address Target
1 70.150.140.95 DROP
2 70.150.140.96 ACCEPT
Strike ENTER to continue
The default target is............ACCEPT
DROP ? (Y/N), CR for no change) :y