BayTech RPC Single-phase Conbined QS - Manual (Page 31)

RPC with or without Ethernet
30
Memory Usage
Current Routing Cache
IP Data currently held in cache or none upon power cycle.
Route Setup
Every TCP/IP client machine, regardless of operating system, needs to make decisions about where to
send a packet after it has been addressed. The route table is the network map that tells your Baytech
product how to deliver the packet to its network addressee.
• Destination, is a list of routes. “0” represents any number.
• Gateway, is the network gateway for the route. The connection point to your company network.
• Genmask, defines how closely an address must match the network destination, octet by octet, to
use the route.
• Iface, interface used to reach the network gateway, in this case Baytech network card.
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.2.0 * 255.255.255.0 U 0 0 0 eth0
127.0.0.0 * 255.0.0.0 U 0 0 0 lo
default 192.168.2.1 0.0.0.0 UG 0 0 0 eth0
Press ENTER to continue
total: used: free: shared: buffers: cached:
Mem: 11735040 4136960 7598080 0 380928 458752
Swap: 0 0 0
Press ENTER to continue
Kernel IP routing cache
Source Destination Gateway Flags Metric Ref Use Iface
66.186.36.195 70.150.140.86 70.150.140.86 l 0 0 1 lo
70.150.140.86 66.186.36.195 70.150.140.65 0 0 0 eth0
70.150.140.69 70.150.140.86 70.150.140.86 il 0 0 154 lo
207.206.133.250 70.150.140.86 70.150.140.86 l 0 0 76 lo
Press ENTER to continue