BayTech RPC Single-phase Conbined QS - Manual (Page 23)

RPC with or without Ethernet
22
Logging Out
Type Logout, Logoff, or Exit at the prompt to logoff from the unit.
Current User Password:
Type ‘password’ at the prompt to change the current user’s password and the RPC will display the
following:
If the current user already has a password the RPC will display the following:
NOTE: If you do not have the user’s current password, delete the user. Reinstall user. Select
option to change password and the RPC will respond asking for a new password.
Identify Current User
Type ‘whoami’ at the prompt to determine the current user, the RPC displays the following:
To change the user logout of the unit and log back in using the new user name.
Unit Identification
Type ‘unitid’ at the prompt to determine the Unit ID, the RPC displays the following:
To change the unit ID, go the Outlet Configuration menu and select ‘Change Unit ID’ option. The
maximum field length is 32 or 16 for older units.
RPC Configuration Menu
To select the configuration menu, type ‘config’ at the prompt.
NOTE: If the unit display with the following message, “Configuration mode in use” A user
in the other port is in the “Configuration” menu.
Enter new Password:
Re-Enter new Password:
Enter old Password:
Enter new Password:
Re-Enter new Password:
Current User: root
Unit ID: RPC3ADE-20
RPC-4>config
Unit ID: RPC3ADE-20
1)...Manage
Users Add/Delete/Rename, assign outlets
2)...Change Outlet Name Select an outlet to change its name
3)...Enable/Disable Confirmation Confirmation (Y/N)
4)...Enable/Disable Status Menu Opening status of outlets
5)...Change Unit ID As written
6)...Change Alarm Threshold As written
X)...Exit