BayTech RPC Single-phase Conbined QS - Manual (Page 13)

RPC with or without Ethernet
12
Interior Architecture
Horizontal Units
Vertical Units
Status Screen:
Once the serial connection is made using the terminal software, the screen
will display the inherent state of the outlets, the Average Power, RMS voltage, Current and Maximum
Detected Current both in Amps, circuit breaker, Internal temperature of the unit, and external
temperature sensors if connected. The number of outlets displayed depends on the RPC model.
Figure 1
Power Controller: The power controller
connects to the relay board to control the
outlets. EIA-232 Port maybe on either
controller.
Power Controller: The power controller
connects to the relay board to control the
outlets. EIA-232 located on Controller.
Unit ID: RPC3ADE-20
-------------------------------------------------------------------------------
| Outlet | True RMS | Peak RMS | True RMS | Average | Volt- |
| Group | Current | Current | Voltage | Power | Amps |
-------------------------------------------------------------------------------
| Outlet 1-8 | 0.2 Amps | 0.2 Amps | 120.7 Volts | 23 Watts | 23 VA |
-------------------------------------------------------------------------------
Internal Temperature: 73.4 F Ext: 68.2 F
Switch 1: Open 2: Open
1)...Outlet 1 : On
2)...Outlet 2 : On
3)...Outlet 3 : On
4)...Outlet 4 : On
5)...Outlet 5 : On
6)...Outlet 6 : On
7)...Outlet 7 : On
8)...Outlet 8 : On
Type Help for a list of commands
RPC>