Default setting is enabled – BayTech RPC Single-phase Conbined QS User Manual

Page 27

RPC with or without Ethernet

Type a new receptacle name (maximum 16 characters), followed by . For example, change the
name of Outlet 4 to Router 1 by typing Router 1 at the “Enter Request” prompt, followed by . The
RPC redisplays the outlet menu with the new name to Outlet 4.

Enable/Disable Confirmation
Select “Enable/Disable Confirmation.” from the main menu. The RPC unit will display the following:

Default setting is Enabled.
Type ‘Y’ to enable the confirmation option, or type ‘N’ to disable. If the confirmation feature is
enabled and a command is sent to TURN ON, TURN OFF, OR REBOOT a receptacle, the RPC will
ask to confirm the command. For example, the command “ON 3” is sent, and the RPC will display the
following:

If this feature is disabled, the RPC will perform the command and redisplay the previous menu.

Enable/Disable Status Menu
Select “Enable/Disable Status Menu.” from the configuration menu, to enable the Status menu.
The RPC will display the option to change the current status:

Default setting is Enabled.

If this feature is disabled, only the RPC> prompt appears, else the following status menu appears.

Change Unit ID

Select “Change Unit ID” from the configuration menu. The RPC will display the following:

Enable Confirmation (Y/N)? y

Turn On Outlet 3? (Y/N)

Enable Status Menu (Y/N)? y

Switch 1: Open 2: Open

1)...Outlet 1 : On
2)...Outlet 2 : On
3)...Outlet 3 : On
4)...Outlet 4 : On
5)...Outlet 5 : On
6)...Outlet 6 : On
7)...Outlet 7 : On
8)...Outlet 8 : On

Type Help for a list of commands

RPC>

This manual is related to the following products:

Combined RPC Quick Start