BayTech RPC Single-phase Conbined QS - Manual (Page 43)

RPC with or without Ethernet
42
NOTE: There should be no active connections while configuring the RPC module. The unit
should be reset upon completion of configuration.
Subnet Mask
The Subnet Mask is a bit mask that identifies the network portion of the IP address, allowing the RPC
to determine whether to send a packet directly to the client or to a gateway. The Subnet Mask consists
of four bytes, each byte ranging from 0 to 255. This parameter must be programmed before the
DS-Series can be accessed through the network.
Select 2) to enter the Subnet Mask followed by . Failure to enter the address in the decimal form
causes the RPC to display the following until it is entered correctly. Default Subnet Mask is 0.0.0.0.
Gateway Address
The Gateway is the address of a router to connect to other parts of a network. The Gateway address
consists of four bytes, each byte ranging from 0 to 255. If your network uses gateways, this parameter
must be programmed before the RPC can be accessed through the network.
Select 3) to enter the Gateway address. Failure to enter the address in the decimal form causes the
RPC to display the following until it is entered correctly. Default Gateway address is 0.0.0.0.
Inactivity Timeout
This option enables the RPC to disconnect after the programmed amount of time, if there is no activity.
Default is 0 (DISABLED). The enabling input can be from 1 to 120 minutes.
Carriage Return Translation
This option determines what the telnet processor will do with the line-feeds and nulls after a carriage
return is sent. Enable tells the RPC Telnet processor to strip line feeds or nulls Translation after the
carriage returns. Disable allows the characters to pass through. Default is “DISABLED”.
Break Length
Users may configure the RPC for a break length of 1 - 1000 milliseconds. In a Telnet session with the
RPC through the serial port of a DS74, send a Telnet break command (0xF3) to the RPC, the serial
port will send a break signal of the programmed duration. Default is 350 milliseconds.
Carriage Return Translation is.... Enabled
Enable ? (Y/N), CR for no change) :
Connection Inactivity Timeout is 0 minutes
Enter timeout, in minutes (<=120, 0 to disable) :
Enter Gateway address in dotted decimal form :
Enter Subnet Mask in dotted decimal form :
Break Length is (msec)............ 350
Enter break length, in milliseconds (<=10000, 0 to disable) :