Configuration menu – BayTech RPC Single-phase Conbined QS User Manual
Page 33
RPC with or without Ethernet
32
Configuration Menu:
NOTE: If the unit display with the following message, “Configuration mode in use” A user
in the other port is in the “Configuration” menu
Copyright(C) Bay Technical Associates 2003
URPC Ethernet Host Module
Revision F 1.07.05 Module 1
Hardware 1.01 Serial number 3800024 colilo version 1.05.01
Status..........................1
Status of all network options
Serial Port Configuration.......2
Setup the Serial port EIA232
Serial Port Device Name.........3
Change the EIA232 port name
Attention Character.............4
Type 5 times to access Network Main menu.
Disconnect Timeguard............5
Data received within the delay period,
is
data,
not
attention
character;
thereby
preventing
unwanted
port
disconnection
Connect Port ID Echo............6
Echo port name or module# & port#
Login Setup.....................7
Login Menu Serial/Telnet/Radius/TACACS
access
control,
manage
users
Network Port Configuration......8
Network Port IP Address
Module Name.....................9
Change name of module
SNMP Configuration.............10
Trap address, Read/Write community names,
Enable/Disable
SNMP
RPC Management.................11
Set up Voltage/Current/Sensor threshold
Web Server Configuration.......12
Enable/Disable Web, login, secure.
Radius Configuration...........13
Enable login, IP Address, Backup server,
Login
timeout
for
Authentication
server
Exit.........................X,CR
Enter Request :