BayTech RPC Single-phase Conbined QS - Manual (Page 18)

RPC with or without Ethernet
17
Access Control
Enable or disable usernames and passwords for both network and serial port access.
If either login has been enabled you will get a prompt similar to the following:
The default user and password is “root/baytech”, all lower case.
Manage Users
Add/delete users and change their passwords. Usernames and passwords are case sensitive and
alphanumeric. The root user can not be removed.
Figure 10
Network Port Configuration
For network access, you must configure the IP addresses, Subnet Mask, and Gateway Address, or
enable the DHCP. The Changes must be saved and the module reset for network changes to take effect.
User Management Menu
To change user password or port access, enter number of user.
To add/delete user, select appropriate menu choice.
SNMP V3 requires passwords that are between 8 and 31 characters long
Enter request, CR to exit menus.
A)...Add user
1)...root
Telnet Login Prompt Enable/Disable..1
Serial Login Prompt Enable/Disable..2
Coldfire login: root
Password:
or
Universal RPC login: root
Password: