BayTech RPC Single-phase Conbined QS - Manual (Page 40)

RPC with or without Ethernet
39
Select a user number, the RPC displays the following menu:
Select the Change Password option to change the user password, the RPC displays the following:
If the user does not have a password the RPC will respond for a new password and a confirmation to
re-enter the new password:
Radius Configuration
Radius is used to authenticate logins for the serial and the network ports if passwords and user names
are enabled on the RPC. If the Radius server rejects either the username or password or does not
respond, the RPC will display “Invalid Password”.
Select 1), Radius Enable to turn on and off radius authentication. If enabled, the primary radius server
address must be specified.
Select 2), Radius Server Address is used to specify the radius server IP addresses.
Enter new password (<= 31 characters)>*******
Confirm by re-entering new password>*******
Password change successful.
User Management Menu
To change user password or port access, enter number of user.
To add/delete user, select appropriate menu choice.
SNMP V3 requires passwords that are between 8 and 31 characters long
Enter request, CR to exit menus.
A)...Add user
D)...Delete user
1)...user1
2)...root
Enter Request :2
Change Password.............1
Exit........................X
Enter Request :1
User name: root
Enter old password (CR if none)>*******
Radius Enable....................1
Radius Server Address............2
Radius Backup Server Address.....3
Radius Secret....................4
Enable DS62 usernames as backup..5
Radius Login Timeout.............6
Exit.............................X,CR
Radius login is...................Disabled
Enable ? (Y/N), CR for no change) :