Basler Electric BE1-BPR - Manual (Page 6)

iv BE1-BPR Introduction 9272000990 Rev J
Manual
Revision and Date Change
G, 01/08
 Added GOST-R to Section 1, General Information, Specifications.
 Added manual part number and revision to footers.
 Updated front panel drawings.
F, 08/04
 Text was added to describe the contact sensing circuitry with jumper-
selectable turn-on and turn-off points. A procedure and diagram for
configuring the contact sensing jumpers was added to Section 7.
 Power supply holdup time specification was increased.
 Where applicable, drawings were modified to reflect new front panel
design for horizontal- and vertical- units.
 Figure 7-2 was changed to show revised mounting depth for the
horizontal-mount unit.
 Call-outs were added to Figure 7-5 to identify mounting hole locations
for vertical-mount units used in retrofit installations. M2 panel
openings were added.
 More data about the IRIG input was added to Section 1, General
Information, and Section 7, Installation.
 POSC command and description was added to Section 4, Functional
Description.
 BKRCON command information was altered because of an expanded
Tc and Ti setting range.
 CTI parameter was removed from CT command text and all settings
lists.
 A note box discussing the need to modify older settings files for use
with newer versions of the BE1-BPR was added to Section 6,
Communications.
 Diagrams and text were added to Section 5, BESTlogic
Programmable Logic, Contact Input Logic to better explain the
recognition and debounce settings of the LI command.
 A detailed table of contents was placed at the beginning of
appropriate sections. The table of contents at the beginning of the
manual was simplified by listing only section numbers and titles.
 Manual style was updated.
E, 12/98
 Output relay pickup time for OUT1 was changed to 4 ms typical, 5 ms
maximum.
D, 07/98
 Manual was revised to provide a more complete functional
description.
 Communication command information was summarized in table form
and missing command information was added.
 Panel drilling diagram of Figure 7-5 was updated and connection
diagram of Figure 7-13 was added.
 Appendix A, Terminal Emulation was added.
 Testing procedures of Section 8, Calibration and Testing were
updated and clarified.
 The manual style was updated.
C, 01/96
 Revised manual to include added IRIG-B functions.
B, 07/95
 Made revisions throughout manual to reflect the vertical mounting
option. Added Figures 3-4, 7-3, 7-4, and 7-5.
 Minor corrections were made in Reclosing Mode and FLOG
Command.
 Corrected Figure 4-2.