Basler Electric BE1-BPR User Manual
Page 137
9272000990 Rev J
BE1-BPR Communications
6-9
PW Command
Purpose:
Reads or changes password settings.
Syntax:
PW [<#>[=
Reference:
Section 4, Functional Description, Software Functional Description, Maintenance,
Programming A New Password
QUIT Command
Purpose:
Exits the programming mode and returns the relay to on-line without saving any changes.
Syntax:
QUIT
Reference:
Section 4, Functional Description, Software Functional Description, Changing Parameters
Using Communication Ports
RESET Command
Purpose:
Clears latched target data.
Syntax:
RESET
Reference:
Section 4, Functional Description, Software Functional Description, Target Data,
TARGETS Screen
SAVE Command
Purpose:
Saves programming or settings changes, exits the programming mode, and returns the
relay to an on-line condition.
Syntax:
SAVE
Reference:
Section 4, Functional Description, Software Functional Description, Changing Parameters
Using Communication Ports
SHOWSET Command
Purpose:
Returns a report of relay settings and logic equations.
Syntax:
SHOWSET
Reference:
Section 5, BESTLOGIC Programmable Logic, Miscellaneous Commands
SNAME Command
(Enhanced Relays Only)
Purpose:
Reads or changes the station name and number for COMTRADE reports.
Syntax:
SNAME [=<#>,
Reference:
Section 4, Functional Description, Software Functional Description, Fault Log (Enhanced
Relays Only), Data Acquisition
STATUS Command
Purpose:
Returns a report of inputs, outputs, and internal relay status.
Syntax:
STATUS
Reference:
Section 4, Functional Description, Software Functional Description, Relay Status
TARGET Command
Purpose:
Reads input and output target information
Syntax:
TARGET
Reference:
Section 4, Functional Description, Software Functional Description, Target Data,
TARGETS Screen
TD Command
Purpose:
Reads or changes timer delay settings.
Syntax:
TD[x][=
Reference:
Section 4, Functional Description, Software Functional Description, Relay Setup, Timers