Section 5 operation with m131 option, 1 introduction, 2 configuration – AMETEK M130 User Manual
Page 93: Section 5, Operation with m131 option -1, Introduction -1, Configuration -1, On 5.2), Operation with m131 option
M130/M131 Programming Manual
5-1
SECTION 5
OPERATION WITH M131 OPTION
5.1 I
NTRODUCTION
The following sections describe the operation of the power supply with the M131
option and how to configure the option for your application.
The M131 option enables you to use your power supply as an auxiliary unit. The
master unit would be a power supply with the M130 interface option. The auxiliary unit
or units share the Ethernet address or RS-232 interface with the master unit. Up to 30
auxiliary units can be controlled by the master unit.
This option can be used with the DLM600 and DCS 1kW and 3kW supplies and
supports the SCPI language.
5.2 C
ONFIGURATION
The S1 DIP switch is accessible from the rear panel. It allows configuration of the
M131 for auxiliary operation. Figure 5-1 shows an example of switch settings for the
DLM600 and the DCS 3k power supplies with the M131 option, configured as an
auxiliary at channel 2, in remote mode.
Note: Only the Remote/Local switch is used for Ethernet.
Figure 5-1. DLM600W Configuration for M131 set to Channel 2