AMETEK M130 - Manual (Page 77)

Sorensen Ethernet Option IEEE 488.2 and SCPI Command Operation
M130/M131 Programming Manual 3-27
Command Description SCPI
:GATE
Sets the network gateway IP address for the
device. String is in the format
“NNN.NNN.NNN.NNN” where “NNN” = 0
through 255, inclusive.
:GATE?
Returns the network gateway address for the
device.
:HOST
Set the network Host Name, a 15-character
alphanumeric string.
:HOST?
Returns the network Host Name, a 15 character
alphanumeric string.
:IP
Sets the Primary configuration to STATICIP
mode and sets the network IP address for the
device.
String is in the format “NNN.NNN.NNN.NNN”
where “NNN” = 0 through 255, inclusive.
:IP?
Returns two IP addresses: the first is the IP
address set to be used when the system boots
up; the second is the IP address presently in
use by the power supply. (The first address will
either be 0.0.0.0. if the Primary configuration is
DHCP or DHCP+AUTOIP, or it will be the static
IP last specified).
:LANLED BLINKON Causes LANLED to blink.
:LANLED BLINKOFF Causes LANLED to stop blinking.
:LANLED?
Returns blink state of the LAN LED:
0 – not blinking; 1 – blinking.
:MAC?
Returns the network MAC address.
xx:xx:xx:xx:xx:xx (Hexadecimal digit pairs)
:MASK
Set the network Subnet Mask for the device.
String is in the format “NNN.NNN.NNN.NNN”
where “NNN” = 0 through 255, inclusive.
:MASK?
Returns the network Subnet Mask for the
device.
:NETBUTTON
Returns configuration parameters to factory
default. (Software equivalent of pressing the
Reset switch on the rear panel of the power
supply). You must cycle the power to effect the
change.
The access string is “6867.”
:PINGRESP
Set ping response:
1 = unit responds to ping (response enabled).
0 = ping response is not enabled.
:PINGRESP?
Returns 1 if ping response is enabled.
Returns 0 if ping response is not enabled.