AMETEK M130 - Manual (Page 76)

IEEE 488.2 and SCPI Command Operation Sorensen Ethernet Option
3-26 M130/131 Programming Manual
Command Description SCPI
:LOCLOUT
The SYST[N]:LOCLOUT <0|1|OFF|ON>
command provides a means of controlling the
local lockout functionality that is an alternative to
the low level GPIB or Ethernet LLO command.
A source number may be specified with this
command, thereby allowing selective disabling
of the front panel of a selected source.
In contrast, using the GPIB or Ethernet LLO low
level command causes the master supply, and
all attached online M131 slaves, to be placed
into the local lockout state. To place the master
and all online M131 slaves into the local lockout
state using the SYST[n]:LOCAL:LOCKOUT
command, specify the source number of 0.
To place only one slave into the local lockout
state, specify that slave in the command. For
example, if the slave is source 3, use the
command: SYST3:LOCAL:LOCKOUT 1.
:SLAVEBAUD? Returns the baud rate for the slave.
:UPGRADE Forces slave to jump to its boot loader.
:NET Network device
:AUTOIP
Sets the network Auto IP mode in the Primary
configuration without affecting the Secondary
configuration..
0 = disable AutoIP; 1 = enable AutoIP
:AUTOIP?
Returns 1 if AutoIP is enabled in the Primary
configuration.
Returns 0 if AutoIP is disabled in the Primary
configuration.
:DESC
Set the network Description, a 64 character
alphanumeric string
:DESC? Returns the network Description.
:DHCPMODE
Sets the network DHCP Mode in the Primary
configuration without affecting the Secondary
configuration.
0 = disable DHCP; 1 = enable DHCP
:DHCPMODE?
Returns 1 if DHCP Mode is enabled in the
Primary configuration.
Returns 0 if DHCP mode is disabled in the
Primary configuration.
:DNS
Sets the network DNS IP address for the
device. String is in the format
“NNN.NNN.NNN.NNN”
where “NNN” = 0 through 255, inclusive.
:DNS?
Returns the network DNS address for the
device.