2 programmable functions, 3 readback functions, 3 specifications – AMETEK M130 User Manual
Page 15: 1 ethernet/lan configuration, Programmable functions -3, Readback functions -3, Specifications -3, Ethernet/lan configuration -3
Sorensen Ethernet Option
Features, Functions and Specifications
M130/M131 Programming Manual
1-3
• Rear panel Ethernet/IEEE-802.3 and RS-232 control interface
• Rear panel User Control Signal interface
• Rear panel configuration switch
1.2.2
P
ROGRAMMABLE
F
UNCTIONS
• Output voltage and current
• Soft limits for voltage and current
• Overvoltage protection
• Output enable/disable
• Maskable fault interrupt
• Hold and trigger
• External relay control
• Full calibration
1.2.3
R
EADBACK
F
UNCTIONS
• Measured voltage and current
• Voltage and current settings
• Soft voltage and current limits
• Overvoltage protection setting
• Status and Accumulated Status registers
• Programming error codes
• Fault codes
• Manufacturer, power supply model, and firmware version identification
1.3 S
PECIFICATIONS
(SUBJECT TO CHANGE WITHOUT NOTICE)
1.3.1
E
THERNET
/LAN
C
ONFIGURATION
• Ethernet
IEEE 802.3 compliant
• Medium
10/100 base-T
• Connection Monitoring Media Sense supported
• Protocol
TCP/IP, IPV4
• ICMP (ping server)
Enable (default)/Disable
• IP Address Assignment Automatic via DHCP (Primary default), Static, or
Automatic Private IP Addressing (Auto-IP, Secondary
default)
• VXI-11 Discovery
Supported
• Security
Password protected access, and selective
permissions for each user